EQUIPMENT NEEDED

Medium- to high-pressure airless sprayer equipped with a 24-inch wand and a .019 fan tip spray jet.

Medium- to high-pressure washer.

HOW TO APPLY

Note: In hot climates, mist-wet the surface with water and remove any puddles prior to application.

1. Use medium- to high-pressure airless sprayer complete with a 24-inch wand and a .019 fan tip spray jet.

2. Hold spray tip 6 inches from surface.

3. Apply to the point of saturation at the rate of 200 sq. feet per gallon with an overlapping spray pattern of approximately 10% to 15%.

4. Begin applying at the lowest level elevation. For example, walls and slopes should be applied side to side, from the bottom up.

5. Wait 20 to 30 minutes; then pressure wash using a medium- to high-pressure machine.

6. For extremely stained surfaces, you may wish to repeat entire process.

7. Do not apply on frozen substrate or when temperature is near freezing.

8. When applying paint, adhesives or other coatings, wait at least 24 hours after sealing with DENSIFIER PLUS CLEANER (or until contaminants are no longer rising to the surface), then flush surface with water and allow to dry before coating.

9. DENSIFIER PLUS CLEANER may etch glass or dull shiny aluminum and can be difficult to remove from other surfaces once it dries. Cover surrounding surfaces or rinse immediately if sprayed with product.

10. DENSIFIER PLUS CLEANER is safe to use and environmentally friendly. We do recommend use of a painter's mask during application. Refer to MSDS.

[Home]  [Products]  [Successes]  [Search]  [Register]  [About us]  [Site map]

[For Distributors]