Medium-
to high-pressure airless sprayer equipped with a 24-inch wand and a .019 fan tip spray
jet.
Use
medium- to high-pressure airless sprayer complete with a 24-inch wand and a .019 fan tip
spray jet.
Hold
spray tip 6 inches from surface.
Apply
to the point of concrete saturation twice in back-to-back applications. To do this,
visually establish a start and finish point during the first application, then prior to
relocating the spray equipment, apply to same area again using the start and finish points
previously established.
Each
application should be at the rate of 200 square feet per gallon with an overlapping spray
pattern of approximately 10% to 15%. Therefore, estimate volume needed at the rate of 100
square feet per gallon.
Begin
applying at the lowest level elevation. For example, walls and slopes should be applied
side to side, from the bottom up.
Use
overlapping patterns of north and south, east and west strokes.
Wax,
paint or anything else restricting access to concrete's interior must be chemically or
mechanically removed for DENSIFIER FOR REBAR to penetrate.
Do
not apply on frozen substrate or when temperature is near freezing.
When
applying paint, adhesives or other coatings, wait 24 hours after sealing with DENSIFIER
FOR REBAR, then thoroughly vacuum OR flush surface with water and allow to dry before
coating.
For
very oily/greasy surfaces, use DENSIFIER PLUS CLEANER (or clean with detergent and high
pressure hot water) prior to application.
DENSIFIER
FOR REBAR may etch glass or dull shiny aluminum and can be difficult to remove from other
surfaces once it dries. Cover surrounding surfaces or rinse immediately if sprayed with
product.
DENSIFIER
FOR REBAR is safe to use and environmentally friendly. We do recommend use of a painter's
mask during application. Refer to MSDS.
