EQUIPMENT NEEDED
Protecrete Radiance should be applied using a paint roller.
HOW TO APPLY
As a protective coating
Note:
Always start with a clean, bare surface. Remove all dirt and buildups.
-
Using
a paint roller, apply evenly at the rate of about 300 square feet per gallon, depending on
porosity, etc.
-
Allow
at least 24 hours to dry thoroughly. May require more drying time in high traffic areas.
Consult manufacturer.
PRECAUTIONS
Protect
areas not intended for coverage as product is very difficult to remove later. RADIANCE
will damage or kill vegetation and may stain or etch glass or plastic. If contact occurs,
wash immediately with water.
Do
not apply when ambient temperature drops below 55°F.
RADIANCE
will adhere to the first surface it meets, including dirt. If product adheres to dirt, it
will peel up. If this occurs, peel away product, clean surface, and reapply.
When
applied as a coating, RADIANCE must be applied in a thin layer; otherwise the strength of
the bond will be compromised. For a thicker layer, apply a second thin coat 24 hours
later.
RADIANCE
has an almost insignificant trace of VOC. Incidental skin contact is not hazardous, but
ingestion or eye contact should be avoided. We recommend use of a painter's mask during
application. Refer to MSDS.
[Home]
[Products] [Successes]
[Search] [Register] [About us] [Site map]
[For Distributors]
Copyright © 2004
Applied Concrete Technology, Inc. All rights reserved.
Manufacturer:
Applied Concrete Technology, Inc.
Post Office Box 548
Grayslake, IL 60030
(800) 228-6694 or (847) 548-2444
fax (847) 548-2555
Click here to send us e-mail.
|
 |
