EQUIPMENT NEEDED

Using as a protective coating: paint roller
Using as a sand consolidator: low pressure non-atomizing sprayer
Using for crack repair: pointed squeeze bottle

HOW TO APPLY
As a protective coating

Note: Always start with a clean, bare surface. Remove all dirt and buildups.

1. Using a paint roller, apply evenly at the rate of about 300 square feet per gallon, depending on porosity, etc.

2. Allow at least 24 hours to dry thoroughly. May require more drying time in high traffic areas. Consult manufacturer.

As a sand consolidator

1. Use low pressure non-atomizing sprayer.

2. Apply uniformly over pavers and sand at a rate of 150

3.  square feet per gallon.

4. Use a small squeegee to wipe excess product from paver tops into sand joints.

5. Do not allow surplus product to air dry on pavers.

For crack repair

1. Fill cracks with a dry fine sand and cement mixture.

2. Using a pointed squeeze bottle, cover with a bead of REDEEMER.

3. Allow to completely set (at least 24 hours) before installing a film coat over the surface.

PRECAUTIONS

1. Protect areas not intended for coverage as product is very difficult to remove later. REDEEMER will damage or kill vegetation and may stain or etch glass or plastic. If contact occurs, wash immediately with water.

2. Do not apply when ambient temperature drops below 55°F.

3. REDEEMER will adhere to the first surface it meets, including dirt. If product adheres to dirt, it will peel up. If this occurs, peel away product, clean surface, and reapply.

4. When applied as a coating, REDEEMER must be applied in a thin layer; otherwise the strength of the bond will be compromised. For a thicker layer, apply a second thin coat 24 hours later.

5. REDEEMER has an almost insignificant trace of VOC. Incidental skin contact is not hazardous, but ingestion or eye contact should be avoided. We recommend use of a painter's mask during application. Refer to MSDS.

[Home]  [Products]  [Successes]  [Search]  [Register]  [About us]  [Site map]

[For Distributors]